JT Eaton #666N 4-The-Birds Bird Repellent Gel (10 fl oz tube, 12 per case)

$5.75

The JT Eaton 666N 4 the birds bird repellent gel is an ecological and humane way to rid buildings of pest birds without harming them. This bird repellent uses the active ingredient polybutene and can be applied to almost any structure where pest birds rest, roost or nest. The tacky material is uncomfortable for birds and prevents them from nesting wherever it is applied. This repellent comes in a 12-pack of 10-ounce caulking tubes. The JT Eaton 666N 4 the birds bird repellent gel comes with a 1-year limited warranty to protect against defects in material and workmanship.

In stock

SKU: JTEA666 Category:

Product Description

This product may be used to discourage pigeons, starlings and other nuisance birds from roosting or perching on treated ledges, sills, roofs, peaks, cornices, and similar parts of municipal, industrial and commercial buildings, homes, apartment and condominium complexes,
bridges and overpasses and similar structures.

JT EATON 4 THE BIRDS® is a transparent, sticky product that remains tacky at 15° F and will not run at temperatures up to 200° F. Do not apply on location where desirable species of birds might become entangled in the repellent.

One 10 oz. tube of this product will treat 10 linear feet when product is applied in beads 1/2″ wide and 1/2″ high

Product Application: Use a caulking gun and/or a putty knife to apply this product. A properly applied bead of JT EATON 4 THE BIRDS® BIRD REPELLENT looks like this ^ in cross section. Press against surface to ensure good adhesion. To treat ledges or sills, apply beads of repellent no larger than 1/2″ wide by 1/2″ deep at the deepest part in strips no closer than 2″ apart, beginning 1″ in from the outer edge. To treat roofs, peaks, cornices, etc., apply a single bead of repellent along the highest point. A second treatment may be necessary if
product becomes flattened by heavy bird traffic.

Surface Preparation:  Clean surfaces to be treated to promote adhesion of repellent. Wipe or scrape all dust, dirt, droppings, and other loose debris from surfaces. Seal porous surfaces prior to treatment by brushing on one coat of shellac or a 50% solution of white glue, and allow to dry.

One 10 oz. tube of this product will treat 10 linear feet when product is applied in beads 1/2″ wide and 1/2″ high

Partially Filled Cartridges: Replace cap on tip of tube.

Product Clean-up: Use mineral spirits to remove product from treated surfaces, equipment, or other contaminated articles.

Active Ingredient:

Polybutene 93%
Other 7%
Total 100%

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.